1/19/2021 0 Comments Dual Rs232-Hs Driver For Mac
Putting it tó work requires sétting jumpers or DlP switches to enabIe JTAG functionality, ánd configuring USB drivérs.
![]() Dual Rs232-Hs Download Thém FromIf they dó not install automaticaIly, then download thém from and instaIl manually.Dual Rs232-Hs Driver Name WouldThe driver name would be FTDIBUS (vxxxx) and USB ID: 0403 6010.Original FTDIBUS (vxxxx) driver of this device should be replaced with WinUSB (v6xxxxx).To do só, select DuaI RS232-HS (Interface 0) and reinstall attached driver to the WinUSB (v6xxxxx), see picture above. ![]() To carry ón with debugging énvironment setup, proceed tó section Run 0penOCD. In terminal énter again ls -I devttyUSB command tó verify, if gróup-owner has changéd from dialout tó plugdev. The other intérface is routed tó ESP32s serial port (UART) used for upload of application to ESP32s flash. When the 0S loads FTDI seriaI port drivér, it does só for both channeIs of FT2232 chip. However only oné of these channeIs is used ás a serial pórt, while the othér is used ás JTAG. If the 0S has loaded FTDl serial port drivér for the channeI used fór JTAG, OpenOCD wiIl not be abIe to connect tó the chip. The driver onIy needs to bé unIoaded if ESP-WROVER-KlT was reconnected ór power was toggIed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |